TIMKEN 34301-34481-B Bearing

TIMKEN 34301-34481-B tapered bearings with Flange

Also known as : 34301-34481-B

• Inside Diameter: 76.2 mm
• Outside Diameter: 122.238 mm
• Width: 7.94 mm
• Basic dynamic load rating: 102 kN
• Basic static load rating: 136 kN

Inquire Now

TIMKEN 34301-34481-B Bearing

Series	34000
model	34301-34481-B
Cone Part Number	34301
Cup Part Number	34481-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.800 Kg 1.70 lb
Dimensions
d - Bore	76.2 mm 3 in
D - Cup Outer Diameter	122.238 mm 4.8125 in
D1 - Flange Outer Diameter	126.901 mm 4.9961 in
B - Cone Width	23.012 mm 0.9060 in
C - Cup Width	21.430 mm 0.8437 in
C1 - Cup Flange Width	4.763 mm 0.1875 in
T - Bearing Width to Flange	7.940 mm 0.3126 in
T1 - Bearing Width	24.608 mm 0.9688 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	3.600 mm 0.14 in
r - Cup Backface "To Clear" Radius	2 mm 0.08 in
da - Cone Frontface Backing Diameter	83.10 mm 3.27 in
db - Cone Backface Backing Diameter	88.90 mm 3.5 in
Da - Cup Frontface Backing Diameter	118.11 mm 4.67 in
Ab - Cage-Cone Frontface Clearance	2.5 mm 0.1 in
Aa - Cage-Cone Backface Clearance	2.3 mm 0.09 in
a - Effective Center Location	1.5 mm 0.06 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	26500 N 5960 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	102000 N 23000 lbf
C0 - Static Radial Rating	136000 N 30600 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	20500 N 4600 lbf
Factors
K - Factor	1.3
e - ISO Factor	0.45
Y - ISO Factor	1.33
G1 - Heat Generation Factor (Roller-Raceway)	69.3
G2 - Heat Generation Factor (Rib-Roller End)	27
Cg - Geometry Factor	0.109

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 34301-34481-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.