TIMKEN 835-832-B tapered bearings with Flange
Also known as : 835-832-B
- Inside Diameter: 69.85 mm
- Outside Diameter: 168.275 mm
- Width: 22.225 mm
- Basic dynamic load rating: 485 kN
- Basic static load rating: 522 kN
TIMKEN 835-832-B Bearing
TIMKEN 835-832-B Bearing details
| Series | 835 |
|---|---|
| model | 835-832-B |
| Cone Part Number | 835 |
| Cup Part Number | 832-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
6.300 Kg 13.80 lb |
| Dimensions | |
| d - Bore |
69.850 mm 2.7500 in |
| D - Cup Outer Diameter |
168.275 mm 6.6250 in |
| D1 - Flange Outer Diameter |
177.698 mm 6.9960 in |
| B - Cone Width |
56.363 mm 2.2190 in |
| C - Cup Width |
41.275 mm 1.6250 in |
| C1 - Cup Flange Width |
9.525 mm 0.3750 in |
| T - Bearing Width to Flange |
22.225 mm 0.8750 in |
| T1 - Bearing Width |
53.975 mm 2.1250 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
3.600 mm 0.14 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
84.10 mm 3.31 in |
| db - Cone Backface Backing Diameter |
90.90 mm 3.58 in |
| Da - Cup Frontface Backing Diameter |
154.94 mm 6.14 in |
| Ab - Cage-Cone Frontface Clearance |
2.5 mm 0.1 in |
| Aa - Cage-Cone Backface Clearance |
3.3 mm 0.13 in |
| a - Effective Center Location |
-18.5 mm -0.73 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
126000 N 28300 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
485000 N 109000 lbf |
| C0 - Static Radial Rating |
522000 N 117000 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
64400 N 14500 lbf |
| Factors | |
| K - Factor | 1.95 |
| e - ISO Factor | 0.3 |
| Y - ISO Factor | 2 |
| G1 - Heat Generation Factor (Roller-Raceway) | 198 |
| G2 - Heat Generation Factor (Rib-Roller End) | 34.8 |
| Cg - Geometry Factor | 0.0937 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 835-832-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
