TIMKEN H715345-H715310-B Bearing

TIMKEN H715345-H715310-B tapered bearings with Flange

Also known as : H715345-H715310-B

  • Inside Diameter: 71.438 mm
  • Outside Diameter: 139.7 mm
  • Width: 17.463 mm
  • Basic dynamic load rating: 319 kN
  • Basic static load rating: 405 kN

Inquire Now


TIMKEN H715345-H715310-B Bearing

TIMKEN H715345-H715310-B Bearing details

Series H715300
model H715345-H715310-B
Cone Part Number H715345
Cup Part Number H715310-B
Design Units Imperial
Cage Type Stamped Steel
Bearing Weight 3.500 Kg
7.70 lb
Dimensions
d - Bore 71.438 mm
2.8125 in
D - Cup Outer Diameter 139.700 mm
5.5000 in
D1 - Flange Outer Diameter 152.400 mm
6 in
B - Cone Width 46.038 mm
1.8125 in
C - Cup Width 36.513 mm
1.4375 in
C1 - Cup Flange Width 7.938 mm
0.3125 in
T - Bearing Width to Flange 17.463 mm
0.6875 in
T1 - Bearing Width 46.038 mm
1.8125 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius 3.600 mm
0.14 in
r - Cup Backface "To Clear" Radius 3.30 mm
0.130 in
da - Cone Frontface Backing Diameter 87.90 mm
3.46 in
db - Cone Backface Backing Diameter 94 mm
3.7 in
Da - Cup Frontface Backing Diameter 135.89 mm
5.35 in
Ab - Cage-Cone Frontface Clearance 2.8 mm
0.11 in
Aa - Cage-Cone Backface Clearance 3.6 mm
0.14 in
a - Effective Center Location -8.6 mm
-0.34 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions) 82700 N
18600 lbf
C1 - Dynamic Radial Rating (1 million revolutions) 319000 N
71700 lbf
C0 - Static Radial Rating 405000 N
91000 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions) 67000 N
15100 lbf
Factors
K - Factor 1.24
e - ISO Factor 0.47
Y - ISO Factor 1.27
G1 - Heat Generation Factor (Roller-Raceway) 147
G2 - Heat Generation Factor (Rib-Roller End) 32.8
Cg - Geometry Factor 0.0993

As TIMKEN bearing distributor, Nodes bearings have TIMKEN H715345-H715310-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.