TIMKEN 55200-55437-B Bearing

TIMKEN 55200-55437-B tapered bearings with Flange

Also known as : 55200-55437-B

• Inside Diameter: 50.8 mm
• Outside Diameter: 111.125 mm
• Width: 15.083 mm
• Basic dynamic load rating: 126 kN
• Basic static load rating: 119 kN

Inquire Now

TIMKEN 55200-55437-B Bearing

Series	55000
model	55200-55437-B
Cone Part Number	55200
Cup Part Number	55437-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	1.300 Kg 2.80 lb
Dimensions
d - Bore	50.8 mm 2 in
D - Cup Outer Diameter	111.125 mm 4.3750 in
D1 - Flange Outer Diameter	116.683 mm 4.5938 in
B - Cone Width	26.909 mm 1.0594 in
C - Cup Width	20.638 mm 0.8125 in
C1 - Cup Flange Width	5.558 mm 0.2188 in
T - Bearing Width to Flange	15.083 mm 0.5938 in
T1 - Bearing Width	30.163 mm 1.1875 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	3.600 mm 0.14 in
r - Cup Backface "To Clear" Radius	3.30 mm 0.130 in
da - Cone Frontface Backing Diameter	63.80 mm 2.51 in
db - Cone Backface Backing Diameter	71.10 mm 2.8 in
Da - Cup Frontface Backing Diameter	106.93 mm 4.25 in
Ab - Cage-Cone Frontface Clearance	4.1 mm 0.16 in
Aa - Cage-Cone Backface Clearance	4.1 mm 0.16 in
a - Effective Center Location	7.1 mm 0.28 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	32700 N 7350 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	126000 N 28300 lbf
C0 - Static Radial Rating	119000 N 26700 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	49500 N 11100 lbf
Factors
K - Factor	0.66
e - ISO Factor	0.88
Y - ISO Factor	0.68
G1 - Heat Generation Factor (Roller-Raceway)	36.8
G2 - Heat Generation Factor (Rib-Roller End)	13.2
Cg - Geometry Factor	0.109

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 55200-55437-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.