TIMKEN 59201-59412-B tapered bearings with Flange
Also known as : 59201-59412-B
- Inside Diameter: 50.8 mm
- Outside Diameter: 104.775 mm
- Width: 11.908 mm
- Basic dynamic load rating: 202 kN
- Basic static load rating: 202 kN
TIMKEN 59201-59412-B Bearing
TIMKEN 59201-59412-B Bearing details
| Series | 59000 |
|---|---|
| model | 59201-59412-B |
| Cone Part Number | 59201 |
| Cup Part Number | 59412-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
1.400 Kg 3.200 lb |
| Dimensions | |
| d - Bore |
50.8 mm 2 in |
| D - Cup Outer Diameter |
104.775 mm 4.1250 in |
| D1 - Flange Outer Diameter |
110.500 mm 4.3504 in |
| B - Cone Width |
36.513 mm 1.4375 in |
| C - Cup Width |
28.575 mm 1.1250 in |
| C1 - Cup Flange Width |
3.970 mm 0.1563 in |
| T - Bearing Width to Flange |
11.908 mm 0.4688 in |
| T1 - Bearing Width |
36.513 mm 1.4375 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
0.800 mm 0.03 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
61 mm 2.4 in |
| db - Cone Backface Backing Diameter |
62 mm 2.44 in |
| Da - Cup Frontface Backing Diameter |
102.10 mm 4.02 in |
| Ab - Cage-Cone Frontface Clearance |
2.3 mm 0.09 in |
| Aa - Cage-Cone Backface Clearance |
2.8 mm 0.11 in |
| a - Effective Center Location |
-9.7 mm -0.38 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
52400 N 11800 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
202000 N 45500 lbf |
| C0 - Static Radial Rating |
202000 N 45400 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
36100 N 8110 lbf |
| Factors | |
| K - Factor | 1.45 |
| e - ISO Factor | 0.40 |
| Y - ISO Factor | 1.49 |
| G1 - Heat Generation Factor (Roller-Raceway) | 57.3 |
| G2 - Heat Generation Factor (Rib-Roller End) | 14.7 |
| Cg - Geometry Factor | 0.0999 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 59201-59412-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
