FAG HS71910-E-T-P4S Bearing

FAG HS71910-E-T-P4S spindle bearings | 50x72x12mm

Also known as : HS71910-E-T-P4S

• Inside Diameter: 50 mm
• Outside Diameter: 72 mm
• Width: 12 mm
• Basic dynamic load rating: 9.4 kN
• Basic static load rating: 6.1 kN

Inquire Now

FAG HS71910-E-T-P4S Bearing

Number	HS71910-E-T-P4S
Type	FAG spindle bearings adjusted, in pairs or sets, contact angle a = 25°, restricted tolerances
d	50 mm
D	72 mm
B	12 mm
a	20,2 mm
Da	67,5 mm	Tolerance: H12
da	55 mm	Tolerance: h12
Etk max	59,1 mm
Etk min	58,2 mm
Etk1 max	59,1 mm
Etk1 min	56,4 mm
r1 min	0,6 mm
ra max	0,6 mm
ra1 max	0,15 mm
rmin	0,6 mm
α	25 °	Contact angle
m	0,138 kg	≈ Mass
Cr	9400 N	Basic dynamic load rating, radial
C0r	6100 N	Basic static load rating, radial
Cur	630 N	Fatigue limit load, radial
nG Fett	24000 1/min	Limiting speed for grease lubrication The limiting speeds are based on elastically preloaded single bearings.
nG Öl	36000 1/min	Limiting speed for minimal quantity oil lubrication The limiting speeds are based on elastically preloaded single bearings.
FV L	56 N	Preload force
FV M	169 N	Preload force
FV H	338 N	Preload force
KaE L	163 N	Lift-off force
KaE M	497 N	Lift-off force
KaE H	1014 N	Lift-off force
ca L	81,7 N/µm	Axial rigidity
ca M	122 N/µm	Axial rigidity
ca H	159 N/µm	Axial rigidity

Nodes bearings have FAG HS71910-E-T-P4S spindle bearings in stock, FAG bearings, precision spindle bearings, adjusted, in pairs or sets, contact angle α = 25°, restricted tolerances.