TIMKEN 05075-05185-B Bearing

TIMKEN 05075-05185-B tapered bearings with Flange

Also known as : 05075-05185-B

• Inside Diameter: 19.05 mm
• Outside Diameter: 47 mm
• Width: 6.038 mm
• Basic dynamic load rating: 26700 kN
• Basic static load rating: 25400 kN

Inquire Now

TIMKEN 05075-05185-B Bearing

Series	05000
model	05075-05185-B
Cone Part Number	05075
Cup Part Number	05185-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.400 Kg 1.00 lb
Dimensions
d - Bore	19.050 mm 0.7500 in
D - Cup Outer Diameter	47.000 mm 1.8504 in
D1 - Flange Outer Diameter	50.861 mm 2.0024 in
B - Cone Width	14.381 mm 0.5662 in
C - Cup Width	11.113 mm 0.4375 in
C1 - Cup Flange Width	2.769 mm 0.1090 in
T - Bearing Width to Flange	6.038 mm 0.2377 in
T1 - Bearing Width	14.381 mm 0.5662 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	1.300 mm 0.050 in
r - Cup Backface "To Clear" Radius	1.5 mm 0.06 in
da - Cone Frontface Backing Diameter	23.60 mm 0.93 in
db - Cone Backface Backing Diameter	24.90 mm 0.98 in
Da - Cup Frontface Backing Diameter	45.47 mm 1.79 in
Ab - Cage-Cone Frontface Clearance	1.8 mm 0.07 in
Aa - Cage-Cone Backface Clearance	-0.3 mm -0.01 in
a - Effective Center Location	-4.1 mm -0.16 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	6930 N 1560 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	26700 N 6010 lbf
C0 - Static Radial Rating	25400 N 5720 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	4230 N 952 lbf
Factors
K - Factor	1.64
e - ISO Factor	0.36
Y - ISO Factor	1.68
G1 - Heat Generation Factor (Roller-Raceway)	5.8
G2 - Heat Generation Factor (Rib-Roller End)	5.55
Cg - Geometry Factor	0.0448

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 05075-05185-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.