TIMKEN 07100-SA-07210XB Bearing

TIMKEN 07100-SA-07210XB tapered bearings with Flange

Also known as : 07100-SA-07210XB

• Inside Diameter: 25.4 mm
• Outside Diameter: 50.8 mm
• Width: 5.08 mm
• Basic dynamic load rating: 29.1 kN
• Basic static load rating: 29.6 kN

Inquire Now

TIMKEN 07100-SA-07210XB Bearing

Series	07000
model	07100-SA-07210XB
Cone Part Number	07100-SA
Cup Part Number	07210XB
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.200 Kg 0.4 lb
Dimensions
d - Bore	25.400 mm 1.0000 in
D - Cup Outer Diameter	50.8 mm 2 in
D1 - Flange Outer Diameter	54.762 mm 2.1560 in
B - Cone Width	14.260 mm 0.5614 in
C - Cup Width	12.700 mm 0.5000 in
C1 - Cup Flange Width	2.769 mm 0.1090 in
T - Bearing Width to Flange	5.080 mm 0.2000 in
T1 - Bearing Width	15.011 mm 0.5910 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	3.300 mm 0.130 in
r - Cup Backface "To Clear" Radius	1.5 mm 0.06 in
da - Cone Frontface Backing Diameter	29.5 mm 1.16 in
db - Cone Backface Backing Diameter	35.10 mm 1.38 in
Da - Cup Frontface Backing Diameter	49.02 mm 1.95 in
Ab - Cage-Cone Frontface Clearance	2 mm 0.08 in
Aa - Cage-Cone Backface Clearance	0 mm 0 in
a - Effective Center Location	-2.8 mm -0.11 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	7550 N 1700 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	29100 N 6540 lbf
C0 - Static Radial Rating	29600 N 6650 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	5190 N 1170 lbf
Factors
K - Factor	1.45
e - ISO Factor	0.40
Y - ISO Factor	1.49
G1 - Heat Generation Factor (Roller-Raceway)	7.6
G2 - Heat Generation Factor (Rib-Roller End)	7.07
Cg - Geometry Factor	0.0509

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 07100-SA-07210XB bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.