TIMKEN 09075-09195AB Bearing

TIMKEN 09075-09195AB tapered bearings with Flange

Also known as : 09075-09195AB

• Inside Diameter: 18.999 mm
• Outside Diameter: 49.225 mm
• Width: 9.601 mm
• Basic dynamic load rating: 42800 kN
• Basic static load rating: 40500 kN

Inquire Now

TIMKEN 09075-09195AB Bearing

Series	09000
model	09075-09195AB
Cone Part Number	09075
Cup Part Number	09195AB
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.100 Kg 0.30 lb
Dimensions
d - Bore	18.999 mm 0.7480 in
D - Cup Outer Diameter	49.225 mm 1.9380 in
D1 - Flange Outer Diameter	53.081 mm 2.0898 in
B - Cone Width	22.332 mm 0.8792 in
C - Cup Width	14.288 mm 0.5625 in
C1 - Cup Flange Width	3.251 mm 0.1280 in
T - Bearing Width to Flange	9.601 mm 0.3780 in
T1 - Bearing Width	20.638 mm 0.8125 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	2.300 mm 0.090 in
r - Cup Backface "To Clear" Radius	1.30 mm 0.050 in
da - Cone Frontface Backing Diameter	23.90 mm 0.94 in
db - Cone Backface Backing Diameter
Da - Cup Frontface Backing Diameter	46.99 mm 1.85 in
Ab - Cage-Cone Frontface Clearance	1.5 mm 0.06 in
Aa - Cage-Cone Backface Clearance	2.5 mm 0.1 in
a - Effective Center Location	-9.9 mm -0.39 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	11100 N 2500 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	42800 N 9630 lbf
C0 - Static Radial Rating	40500 N 9100 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	5050 N 1140 lbf
Factors
K - Factor	2.2
e - ISO Factor	0.27
Y - ISO Factor	2.26
G1 - Heat Generation Factor (Roller-Raceway)
G2 - Heat Generation Factor (Rib-Roller End)
Cg - Geometry Factor	0.0452

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 09075-09195AB bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.