TIMKEN 15101-15250-B Bearing

TIMKEN 15101-15250-B tapered bearings with Flange

Also known as : 15101-15250-B

• Inside Diameter: 25.4 mm
• Outside Diameter: 63.5 mm
• Width: 8.73 mm
• Basic dynamic load rating: 59.9 kN
• Basic static load rating: 53.9 kN

Inquire Now

TIMKEN 15101-15250-B Bearing

Series	15000
model	15101-15250-B
Cone Part Number	15101
Cup Part Number	15250-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.300 Kg 0.70 lb
Dimensions
d - Bore	25.400 mm 1.0000 in
D - Cup Outer Diameter	63.500 mm 2.5000 in
D1 - Flange Outer Diameter	67.366 mm 2.6522 in
B - Cone Width	20.638 mm 0.8125 in
C - Cup Width	15.875 mm 0.6250 in
C1 - Cup Flange Width	3.967 mm 0.1562 in
T - Bearing Width to Flange	8.730 mm 0.3437 in
T1 - Bearing Width	20.638 mm 0.8125 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	0.800 mm 0.03 in
r - Cup Backface "To Clear" Radius	1.30 mm 0.050 in
da - Cone Frontface Backing Diameter	31.5 mm 1.24 in
db - Cone Backface Backing Diameter	32.5 mm 1.28 in
Da - Cup Frontface Backing Diameter	59.94 mm 2.40 in
Ab - Cage-Cone Frontface Clearance	1.8 mm 0.07 in
Aa - Cage-Cone Backface Clearance	0.8 mm 0.03 in
a - Effective Center Location	-5.8 mm -0.23 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	15500 N 3490 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	59900 N 13500 lbf
C0 - Static Radial Rating	53900 N 12100 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	9310 N 2090 lbf
Factors
K - Factor	1.67
e - ISO Factor	0.35
Y - ISO Factor	1.71
G1 - Heat Generation Factor (Roller-Raceway)	14.6
G2 - Heat Generation Factor (Rib-Roller End)	7.58
Cg - Geometry Factor	0.0606

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 15101-15250-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.