TIMKEN 19143-19283-B Bearing

TIMKEN 19143-19283-B tapered bearings with Flange

Also known as : 19143-19283-B

• Inside Diameter: 36.513 mm
• Outside Diameter: 71.999 mm
• Width: 6.287 mm
• Basic dynamic load rating: 50.7 kN
• Basic static load rating: 57.8 kN

Inquire Now

TIMKEN 19143-19283-B Bearing

Series	19000
model	19143-19283-B
Cone Part Number	19143
Cup Part Number	19283-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.500 Kg 1.00 lb
Dimensions
d - Bore	36.513 mm 1.4375 in
D - Cup Outer Diameter	71.999 mm 2.8346 in
D1 - Flange Outer Diameter	75.857 mm 2.9865 in
B - Cone Width	16.520 mm 0.6504 in
C - Cup Width	14.288 mm 0.5625 in
C1 - Cup Flange Width	3.556 mm 0.1400 in
T - Bearing Width to Flange	6.287 mm 0.2475 in
T1 - Bearing Width	17.018 mm 0.6700 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	1.5 mm 0.06 in
r - Cup Backface "To Clear" Radius	1.5 mm 0.06 in
da - Cone Frontface Backing Diameter	41.40 mm 1.63 in
db - Cone Backface Backing Diameter	43.90 mm 1.73 in
Da - Cup Frontface Backing Diameter	69.09 mm 2.72 in
Ab - Cage-Cone Frontface Clearance	2.3 mm 0.09 in
Aa - Cage-Cone Backface Clearance	0.8 mm 0.03 in
a - Effective Center Location	-1.5 mm -0.06 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	13100 N 2960 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	50700 N 11400 lbf
C0 - Static Radial Rating	57800 N 13000 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	10000 N 2250 lbf
Factors
K - Factor	1.31
e - ISO Factor	0.44
Y - ISO Factor	1.35
G1 - Heat Generation Factor (Roller-Raceway)	17.5
G2 - Heat Generation Factor (Rib-Roller End)	11.5
Cg - Geometry Factor	0.0694

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 19143-19283-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.