TIMKEN 28137-28315-B Bearing

TIMKEN 28137-28315-B tapered bearings with Flange

Also known as : 28137-28315-B

• Inside Diameter: 34.925 mm
• Outside Diameter: 80 mm
• Width: 9.101 mm
• Basic dynamic load rating: 75.2 kN
• Basic static load rating: 68.9 kN

Inquire Now

TIMKEN 28137-28315-B Bearing

Series	28000
model	28137-28315-B
Cone Part Number	28137
Cup Part Number	28315-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.600 Kg 1.20 lb
Dimensions
d - Bore	34.925 mm 1.3750 in
D - Cup Outer Diameter	80 mm 3.1496 in
D1 - Flange Outer Diameter	83.858 mm 3.3015 in
B - Cone Width	20.940 mm 0.8244 in
C - Cup Width	15.875 mm 0.6250 in
C1 - Cup Flange Width	3.970 mm 0.1563 in
T - Bearing Width to Flange	9.101 mm 0.3583 in
T1 - Bearing Width	21.006 mm 0.8270 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	1.5 mm 0.06 in
r - Cup Backface "To Clear" Radius	1.5 mm 0.06 in
da - Cone Frontface Backing Diameter	40.90 mm 1.61 in
db - Cone Backface Backing Diameter	43.40 mm 1.71 in
Da - Cup Frontface Backing Diameter	73.90 mm 2.91 in
Ab - Cage-Cone Frontface Clearance	1.8 mm 0.07 in
Aa - Cage-Cone Backface Clearance	1.5 mm 0.06 in
a - Effective Center Location	-4.8 mm -0.19 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	19500 N 4390 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	75200 N 16900 lbf
C0 - Static Radial Rating	68900 N 15500 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	13400 N 3020 lbf
Factors
K - Factor	1.45
e - ISO Factor	0.40
Y - ISO Factor	1.49
G1 - Heat Generation Factor (Roller-Raceway)	20.7
G2 - Heat Generation Factor (Rib-Roller End)	12.5
Cg - Geometry Factor	0.0709

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 28137-28315-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.