TIMKEN 447-432-B Bearing

TIMKEN 447-432-B tapered bearings with Flange

Also known as : 447-432-B

• Inside Diameter: 41.275 mm
• Outside Diameter: 95.25 mm
• Width: 11.115 mm
• Basic dynamic load rating: 127 kN
• Basic static load rating: 144 kN

Inquire Now

TIMKEN 447-432-B Bearing

Series	435
model	447-432-B
Cone Part Number	447
Cup Part Number	432-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	1.000 Kg 2.30 lb
Dimensions
d - Bore	41.275 mm 1.6250 in
D - Cup Outer Diameter	95.250 mm 3.7500 in
D1 - Flange Outer Diameter	100.686 mm 3.9640 in
B - Cone Width	29.901 mm 1.1772 in
C - Cup Width	22.225 mm 0.8750 in
C1 - Cup Flange Width	5.558 mm 0.2188 in
T - Bearing Width to Flange	11.115 mm 0.4376 in
T1 - Bearing Width	27.783 mm 1.0938 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	3.600 mm 0.14 in
r - Cup Backface "To Clear" Radius	2.30 mm 0.090 in
da - Cone Frontface Backing Diameter	48.5 mm 1.91 in
db - Cone Backface Backing Diameter	55.10 mm 2.17 in
Da - Cup Frontface Backing Diameter	87.12 mm 3.46 in
Ab - Cage-Cone Frontface Clearance	1.3 mm 0.05 in
Aa - Cage-Cone Backface Clearance	1 mm 0.04 in
a - Effective Center Location	-9.1 mm -0.36 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	32900 N 7400 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	127000 N 28500 lbf
C0 - Static Radial Rating	144000 N 32400 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	16000 N 3600 lbf
Factors
K - Factor	2.05
e - ISO Factor	0.28
Y - ISO Factor	2.11
G1 - Heat Generation Factor (Roller-Raceway)	42.5
G2 - Heat Generation Factor (Rib-Roller End)	11.3
Cg - Geometry Factor	0.0805

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 447-432-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.