TIMKEN 45291-45220-B Bearing

TIMKEN 45291-45220-B tapered bearings with Flange

Also known as : 45291-45220-B

  • Inside Diameter: 57.15 mm
  • Outside Diameter: 104.775 mm
  • Width: 11.908 mm
  • Basic dynamic load rating: 153 kN
  • Basic static load rating: 189 kN

Inquire Now


TIMKEN 45291-45220-B Bearing

TIMKEN 45291-45220-B Bearing details

Series 45200
model 45291-45220-B
Cone Part Number 45291
Cup Part Number 45220-B
Design Units Imperial
Cage Type Stamped Steel
Bearing Weight 1.100 Kg
2.40 lb
Dimensions
d - Bore 57.150 mm
2.2500 in
D - Cup Outer Diameter 104.775 mm
4.1250 in
D1 - Flange Outer Diameter 110.231 mm
4.3398 in
B - Cone Width 30.958 mm
1.2188 in
C - Cup Width 23.813 mm
0.9375 in
C1 - Cup Flange Width 5.558 mm
0.2188 in
T - Bearing Width to Flange 11.908 mm
0.4688 in
T1 - Bearing Width 30.163 mm
1.1875 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius 6.400 mm
0.25 in
r - Cup Backface "To Clear" Radius 3.30 mm
0.130 in
da - Cone Frontface Backing Diameter 65 mm
2.56 in
db - Cone Backface Backing Diameter 75.90 mm
2.99 in
Da - Cup Frontface Backing Diameter 102.10 mm
4.02 in
Ab - Cage-Cone Frontface Clearance 2.5 mm
0.1 in
Aa - Cage-Cone Backface Clearance 1.8 mm
0.07 in
a - Effective Center Location -8.1 mm
-0.32 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions) 39700 N
8930 lbf
C1 - Dynamic Radial Rating (1 million revolutions) 153000 N
34500 lbf
C0 - Static Radial Rating 189000 N
42600 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions) 22600 N
5090 lbf
Factors
K - Factor 1.76
e - ISO Factor 0.33
Y - ISO Factor 1.8
G1 - Heat Generation Factor (Roller-Raceway) 63.5
G2 - Heat Generation Factor (Rib-Roller End) 16.9
Cg - Geometry Factor 0.0971

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 45291-45220-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.