TIMKEN 52387-52637-B Bearing

TIMKEN 52387-52637-B tapered bearings with Flange

Also known as : 52387-52637-B

  • Inside Diameter: 98.425 mm
  • Outside Diameter: 161.925 mm
  • Width: 16.667 mm
  • Basic dynamic load rating: 223 kN
  • Basic static load rating: 343 kN

Inquire Now


TIMKEN 52387-52637-B Bearing

TIMKEN 52387-52637-B Bearing details

Series 52000
model 52387-52637-B
Cone Part Number 52387
Cup Part Number 52637-B
Design Units Imperial
Cage Type Stamped Steel
Bearing Weight 2.800 Kg
6.30 lb
Dimensions
d - Bore 98.425 mm
3.8750 in
D - Cup Outer Diameter 161.925 mm
6.3750 in
D1 - Flange Outer Diameter 168.173 mm
6.6210 in
B - Cone Width 36.116 mm
1.4219 in
C - Cup Width 26.195 mm
1.0313 in
C1 - Cup Flange Width 6.350 mm
0.2500 in
T - Bearing Width to Flange 16.667 mm
0.6562 in
T1 - Bearing Width 36.513 mm
1.4375 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius 3.600 mm
0.14 in
r - Cup Backface "To Clear" Radius 3.30 mm
0.130 in
da - Cone Frontface Backing Diameter 108 mm
4.25 in
db - Cone Backface Backing Diameter 114 mm
4.49 in
Da - Cup Frontface Backing Diameter 154.94 mm
6.14 in
Ab - Cage-Cone Frontface Clearance 3 mm
0.12 in
Aa - Cage-Cone Backface Clearance 4.1 mm
0.16 in
a - Effective Center Location -0.5 mm
-0.02 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions) 57900 N
13000 lbf
C1 - Dynamic Radial Rating (1 million revolutions) 223000 N
50200 lbf
C0 - Static Radial Rating 343000 N
77000 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions) 47100 N
10600 lbf
Factors
K - Factor 1.23
e - ISO Factor 0.47
Y - ISO Factor 1.26
G1 - Heat Generation Factor (Roller-Raceway) 175
G2 - Heat Generation Factor (Rib-Roller End) 41.7
Cg - Geometry Factor 0.152

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 52387-52637-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.