TIMKEN 559-552-B Bearing

TIMKEN 559-552-B tapered bearings with Flange

Also known as : 559-552-B

• Inside Diameter: 63.5 mm
• Outside Diameter: 123.825 mm
• Width: 14.288 mm
• Basic dynamic load rating: 226 kN
• Basic static load rating: 248 kN

Inquire Now

TIMKEN 559-552-B Bearing

Series	555
model	559-552-B
Cone Part Number	559
Cup Part Number	552-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	2.100 Kg 4.50 lb
Dimensions
d - Bore	63.500 mm 2.5000 in
D - Cup Outer Diameter	123.825 mm 4.8750 in
D1 - Flange Outer Diameter	130.073 mm 5.1210 in
B - Cone Width	36.678 mm 1.4440 in
C - Cup Width	30.163 mm 1.1875 in
C1 - Cup Flange Width	6.350 mm 0.2500 in
T - Bearing Width to Flange	14.288 mm 0.5625 in
T1 - Bearing Width	38.100 mm 1.5000 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	3.600 mm 0.14 in
r - Cup Backface "To Clear" Radius	3.30 mm 0.130 in
da - Cone Frontface Backing Diameter	74.90 mm 2.95 in
db - Cone Backface Backing Diameter	81 mm 3.19 in
Da - Cup Frontface Backing Diameter	116.84 mm 4.60 in
Ab - Cage-Cone Frontface Clearance	2 mm 0.08 in
Aa - Cage-Cone Backface Clearance	1.8 mm 0.07 in
a - Effective Center Location	-9.4 mm -0.37 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	58600 N 13200 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	226000 N 50800 lbf
C0 - Static Radial Rating	248000 N 55700 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	34700 N 7810 lbf
Factors
K - Factor	1.69
e - ISO Factor	0.35
Y - ISO Factor	1.73
G1 - Heat Generation Factor (Roller-Raceway)	91
G2 - Heat Generation Factor (Rib-Roller End)	21.1
Cg - Geometry Factor	0.111

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 559-552-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.