TIMKEN 56425-56650-B tapered bearings with Flange
Also known as : 56425-56650-B
- Inside Diameter: 107.95 mm
- Outside Diameter: 165.1 mm
- Width: 15.875 mm
- Basic dynamic load rating: 226 kN
- Basic static load rating: 355 kN
TIMKEN 56425-56650-B Bearing
TIMKEN 56425-56650-B Bearing details
| Series | 56000 |
|---|---|
| model | 56425-56650-B |
| Cone Part Number | 56425 |
| Cup Part Number | 56650-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
2.700 Kg 6.00 lb |
| Dimensions | |
| d - Bore |
107.95 mm 4.25 in |
| D - Cup Outer Diameter |
165.1 mm 6.5 in |
| D1 - Flange Outer Diameter |
171.348 mm 6.7460 in |
| B - Cone Width |
36.513 mm 1.4375 in |
| C - Cup Width |
26.988 mm 1.0625 in |
| C1 - Cup Flange Width |
6.350 mm 0.2500 in |
| T - Bearing Width to Flange |
15.875 mm 0.6250 in |
| T1 - Bearing Width |
36.513 mm 1.4375 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
3.600 mm 0.14 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
117.10 mm 4.61 in |
| db - Cone Backface Backing Diameter |
122.9 mm 4.84 in |
| Da - Cup Frontface Backing Diameter |
163.07 mm 6.42 in |
| Ab - Cage-Cone Frontface Clearance |
2 mm 0.08 in |
| Aa - Cage-Cone Backface Clearance |
3.6 mm 0.14 in |
| a - Effective Center Location |
2 mm 0.08 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
58700 N 13200 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
226000 N 50900 lbf |
| C0 - Static Radial Rating |
355000 N 79700 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
50000 N 11200 lbf |
| Factors | |
| K - Factor | 1.18 |
| e - ISO Factor | 0.5 |
| Y - ISO Factor | 1.21 |
| G1 - Heat Generation Factor (Roller-Raceway) | 191 |
| G2 - Heat Generation Factor (Rib-Roller End) | 47.7 |
| Cg - Geometry Factor | 0.158 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 56425-56650-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
