TIMKEN 6580-6535-B tapered bearings with Flange
Also known as : 6580-6535-B
- Inside Diameter: 88.9 mm
- Outside Diameter: 161.925 mm
- Width: 19.05 mm
- Basic dynamic load rating: 439 kN
- Basic static load rating: 523 kN
TIMKEN 6580-6535-B Bearing
TIMKEN 6580-6535-B Bearing details
| Series | 6500 |
|---|---|
| model | 6580-6535-B |
| Cone Part Number | 6580 |
| Cup Part Number | 6535-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
4.800 Kg 10.50 lb |
| Dimensions | |
| d - Bore |
88.900 mm 3.5000 in |
| D - Cup Outer Diameter |
161.925 mm 6.3750 in |
| D1 - Flange Outer Diameter |
171.450 mm 6.7500 in |
| B - Cone Width |
55.100 mm 2.1693 in |
| C - Cup Width |
42.863 mm 1.6875 in |
| C1 - Cup Flange Width |
7.938 mm 0.3125 in |
| T - Bearing Width to Flange |
19.050 mm 0.7500 in |
| T1 - Bearing Width |
53.975 mm 2.1250 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
3.600 mm 0.14 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
102.10 mm 4.02 in |
| db - Cone Backface Backing Diameter |
113 mm 4.45 in |
| Da - Cup Frontface Backing Diameter |
154.94 mm 6.14 in |
| Ab - Cage-Cone Frontface Clearance |
1.5 mm 0.06 in |
| Aa - Cage-Cone Backface Clearance |
3.8 mm 0.15 in |
| a - Effective Center Location |
-13.2 mm -0.52 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
114000 N 25600 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
439000 N 98800 lbf |
| C0 - Static Radial Rating |
523000 N 118000 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
78100 N 17600 lbf |
| Factors | |
| K - Factor | 1.46 |
| e - ISO Factor | 0.40 |
| Y - ISO Factor | 1.5 |
| G1 - Heat Generation Factor (Roller-Raceway) | 199 |
| G2 - Heat Generation Factor (Rib-Roller End) | 33.5 |
| Cg - Geometry Factor | 0.1040 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 6580-6535-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
