TIMKEN 67388-67322-B tapered bearings with Flange
Also known as : 67388-67322-B
- Inside Diameter: 127 mm
- Outside Diameter: 196.85 mm
- Width: 15.083 mm
- Basic dynamic load rating: 368 kN
- Basic static load rating: 625 kN
TIMKEN 67388-67322-B Bearing
TIMKEN 67388-67322-B Bearing details
| Series | 67300 |
|---|---|
| model | 67388-67322-B |
| Cone Part Number | 67388 |
| Cup Part Number | 67322-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
5.300 Kg 11.70 lb |
| Dimensions | |
| d - Bore |
127 mm 5 in |
| D - Cup Outer Diameter |
196.850 mm 7.7500 in |
| D1 - Flange Outer Diameter |
203.891 mm 8.0272 in |
| B - Cone Width |
46.038 mm 1.8125 in |
| C - Cup Width |
38.100 mm 1.5000 in |
| C1 - Cup Flange Width |
7.145 mm 0.2813 in |
| T - Bearing Width to Flange |
15.083 mm 0.5938 in |
| T1 - Bearing Width |
46.040 mm 1.8126 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
3.600 mm 0.14 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
137.90 mm 5.43 in |
| db - Cone Backface Backing Diameter |
144 mm 5.67 in |
| Da - Cup Frontface Backing Diameter |
191.01 mm 7.59 in |
| Ab - Cage-Cone Frontface Clearance |
2.3 mm 0.09 in |
| Aa - Cage-Cone Backface Clearance |
3.3 mm 0.13 in |
| a - Effective Center Location |
-6.4 mm -0.25 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
95300 N 21400 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
368000 N 82600 lbf |
| C0 - Static Radial Rating |
625000 N 141000 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
56100 N 12600 lbf |
| Factors | |
| K - Factor | 1.7 |
| e - ISO Factor | 0.34 |
| Y - ISO Factor | 1.74 |
| G1 - Heat Generation Factor (Roller-Raceway) | 384 |
| G2 - Heat Generation Factor (Rib-Roller End) | 70.1 |
| Cg - Geometry Factor | 0.122 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 67388-67322-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
