TIMKEN 795-792-B tapered bearings with Flange
Also known as : 795-792-B
- Inside Diameter: 120.65 mm
- Outside Diameter: 206.375 mm
- Width: 20.638 mm
- Basic dynamic load rating: 378 kN
- Basic static load rating: 593 kN
TIMKEN 795-792-B Bearing
TIMKEN 795-792-B Bearing details
| Series | 795 |
|---|---|
| model | 795-792-B |
| Cone Part Number | 795 |
| Cup Part Number | 792-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
6.500 Kg 14.400 lb |
| Dimensions | |
| d - Bore |
120.650 mm 4.7500 in |
| D - Cup Outer Diameter |
206.375 mm 8.1250 in |
| D1 - Flange Outer Diameter |
214.213 mm 8.4336 in |
| B - Cone Width |
47.625 mm 1.875 in |
| C - Cup Width |
34.925 mm 1.3750 in |
| C1 - Cup Flange Width |
7.938 mm 0.3125 in |
| T - Bearing Width to Flange |
20.638 mm 0.8125 in |
| T1 - Bearing Width |
47.625 mm 1.8750 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
3.300 mm 0.130 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
134.10 mm 5.28 in |
| db - Cone Backface Backing Diameter |
138.90 mm 5.47 in |
| Da - Cup Frontface Backing Diameter |
198.12 mm 7.83 in |
| Ab - Cage-Cone Frontface Clearance |
4.1 mm 0.16 in |
| Aa - Cage-Cone Backface Clearance |
4.6 mm 0.18 in |
| a - Effective Center Location |
-1.8 mm -0.07 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
98000 N 22000 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
378000 N 85000 lbf |
| C0 - Static Radial Rating |
593000 N 133000 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
77000 N 17300 lbf |
| Factors | |
| K - Factor | 1.27 |
| e - ISO Factor | 0.46 |
| Y - ISO Factor | 1.31 |
| G1 - Heat Generation Factor (Roller-Raceway) | 326 |
| G2 - Heat Generation Factor (Rib-Roller End) | 56.2 |
| Cg - Geometry Factor | 0.127 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 795-792-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
