TIMKEN 936-932-B tapered bearings with Flange
Also known as : 936-932-B
- Inside Diameter: 107.95 mm
- Outside Diameter: 212.725 mm
- Width: 23.813 mm
- Basic dynamic load rating: 572 kN
- Basic static load rating: 786 kN
TIMKEN 936-932-B Bearing
TIMKEN 936-932-B Bearing details
| Series | 935 |
|---|---|
| model | 936-932-B |
| Cone Part Number | 936 |
| Cup Part Number | 932-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
10.80 Kg 23.700 lb |
| Dimensions | |
| d - Bore |
107.95 mm 4.25 in |
| D - Cup Outer Diameter |
212.725 mm 8.3750 in |
| D1 - Flange Outer Diameter |
223.736 mm 8.8085 in |
| B - Cone Width |
66.675 mm 2.6250 in |
| C - Cup Width |
53.975 mm 2.1250 in |
| C1 - Cup Flange Width |
11.113 mm 0.4375 in |
| T - Bearing Width to Flange |
23.813 mm 0.9375 in |
| T1 - Bearing Width |
66.675 mm 2.6250 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
7.900 mm 0.310 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
121.90 mm 4.8 in |
| db - Cone Backface Backing Diameter |
136.90 mm 5.39 in |
| Da - Cup Frontface Backing Diameter |
199.90 mm 7.87 in |
| Ab - Cage-Cone Frontface Clearance |
2.3 mm 0.09 in |
| Aa - Cage-Cone Backface Clearance |
5.8 mm 0.23 in |
| a - Effective Center Location |
-19.8 mm -0.78 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
148000 N 33300 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
572000 N 129000 lbf |
| C0 - Static Radial Rating |
786000 N 177000 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
82700 N 18600 lbf |
| Factors | |
| K - Factor | 1.79 |
| e - ISO Factor | 0.33 |
| Y - ISO Factor | 1.84 |
| G1 - Heat Generation Factor (Roller-Raceway) | 339 |
| G2 - Heat Generation Factor (Rib-Roller End) | 39.7 |
| Cg - Geometry Factor | 0.115 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 936-932-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
