TIMKEN 95528-95925-B Bearing

TIMKEN 95528-95925-B tapered bearings with Flange

Also known as : 95528-95925-B

  • Inside Diameter: 133.35 mm
  • Outside Diameter: 234.95 mm
  • Width: 25.4 mm
  • Basic dynamic load rating: 629 kN
  • Basic static load rating: 931 kN

Inquire Now


TIMKEN 95528-95925-B Bearing

TIMKEN 95528-95925-B Bearing details

Series 95000
model 95528-95925-B
Cone Part Number 95528
Cup Part Number 95925-B
Design Units Imperial
Cage Type Stamped Steel
Bearing Weight 11.70 Kg
25.800 lb
Dimensions
d - Bore 133.350 mm
5.2500 in
D - Cup Outer Diameter 234.95 mm
9.25 in
D1 - Flange Outer Diameter 245.958 mm
9.6834 in
B - Cone Width 63.5 mm
2.5 in
C - Cup Width 49.213 mm
1.9375 in
C1 - Cup Flange Width 11.113 mm
0.4375 in
T - Bearing Width to Flange 25.400 mm
1.0000 in
T1 - Bearing Width 63.500 mm
2.5000 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius 4.800 mm
0.190 in
r - Cup Backface "To Clear" Radius 3.30 mm
0.130 in
da - Cone Frontface Backing Diameter 148.10 mm
5.83 in
db - Cone Backface Backing Diameter 157 mm
6.18 in
Da - Cup Frontface Backing Diameter 216.92 mm
8.58 in
Ab - Cage-Cone Frontface Clearance 4.8 mm
0.19 in
Aa - Cage-Cone Backface Clearance 5.6 mm
0.22 in
a - Effective Center Location -14 mm
-0.55 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions) 163000 N
36700 lbf
C1 - Dynamic Radial Rating (1 million revolutions) 629000 N
141000 lbf
C0 - Static Radial Rating 931000 N
209000 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions) 103000 N
23200 lbf
Factors
K - Factor 1.58
e - ISO Factor 0.37
Y - ISO Factor 1.62
G1 - Heat Generation Factor (Roller-Raceway) 454
G2 - Heat Generation Factor (Rib-Roller End) 59.3
Cg - Geometry Factor 0.132

As TIMKEN bearing distributor, Nodes bearings have TIMKEN 95528-95925-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.