TIMKEN 99575-99100-B tapered bearings with Flange
Also known as : 99575-99100-B
- Inside Diameter: 146.05 mm
- Outside Diameter: 254 mm
- Width: 30.163 mm
- Basic dynamic load rating: 660 kN
- Basic static load rating: 1030 kN
TIMKEN 99575-99100-B Bearing
TIMKEN 99575-99100-B Bearing details
| Series | 99000 |
|---|---|
| model | 99575-99100-B |
| Cone Part Number | 99575 |
| Cup Part Number | 99100-B |
| Design Units | Imperial |
| Cage Type | Stamped Steel |
| Bearing Weight |
13.70 Kg 30.100 lb |
| Dimensions | |
| d - Bore |
146.050 mm 5.7500 in |
| D - Cup Outer Diameter |
254.000 mm 10.0000 in |
| D1 - Flange Outer Diameter |
264.973 mm 10.4320 in |
| B - Cone Width |
66.675 mm 2.6250 in |
| C - Cup Width |
47.625 mm 1.8750 in |
| C1 - Cup Flange Width |
11.113 mm 0.4375 in |
| T - Bearing Width to Flange |
30.163 mm 1.1875 in |
| T1 - Bearing Width |
66.675 mm 2.6250 in |
| Abutment and Fillet Dimensions | |
| R - Cone Backface "To Clear" Radius |
7.100 mm 0.280 in |
| r - Cup Backface "To Clear" Radius |
3.30 mm 0.130 in |
| da - Cone Frontface Backing Diameter |
162.10 mm 6.38 in |
| db - Cone Backface Backing Diameter |
175 mm 6.89 in |
| Da - Cup Frontface Backing Diameter |
238.30 mm 9.38 in |
| Ab - Cage-Cone Frontface Clearance |
4.8 mm 0.19 in |
| Aa - Cage-Cone Backface Clearance |
8.6 mm 0.34 in |
| a - Effective Center Location |
-12.2 mm -0.48 in |
| Basic Load Ratings | |
| C90 - Dynamic Radial Rating (90 million revolutions) |
171000 N 38500 lbf |
| C1 - Dynamic Radial Rating (1 million revolutions) |
660000 N 148000 lbf |
| C0 - Static Radial Rating |
1030000 N 231000 lbf |
| Ca90 - Dynamic Thrust Rating (90 million revolutions) |
119000 N 26800 lbf |
| Factors | |
| K - Factor | 1.43 |
| e - ISO Factor | 0.41 |
| Y - ISO Factor | 1.47 |
| G1 - Heat Generation Factor (Roller-Raceway) | 556 |
| G2 - Heat Generation Factor (Rib-Roller End) | 73.5 |
| Cg - Geometry Factor | 0.146 |
As TIMKEN bearing distributor, Nodes bearings have TIMKEN 99575-99100-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
