TIMKEN A6067-A6157-B Bearing

TIMKEN A6067-A6157-B tapered bearings with Flange

Also known as : A6067-A6157-B

• Inside Diameter: 16.993 mm
• Outside Diameter: 39.992 mm
• Width: 4.851 mm
• Basic dynamic load rating: 13400 kN
• Basic static load rating: 12300 kN

Inquire Now

TIMKEN A6067-A6157-B Bearing

Series	A6000
model	A6067-A6157-B
Cone Part Number	A6067
Cup Part Number	A6157-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.100 Kg 0.20 lb
Dimensions
d - Bore	16.993 mm 0.6690 in
D - Cup Outer Diameter	39.992 mm 1.5745 in
D1 - Flange Outer Diameter	43.066 mm 1.6955 in
B - Cone Width	11.153 mm 0.4391 in
C - Cup Width	9.525 mm 0.3750 in
C1 - Cup Flange Width	2.362 mm 0.0930 in
T - Bearing Width to Flange	4.851 mm 0.1910 in
T1 - Bearing Width	12.014 mm 0.4730 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	0.800 mm 0.03 in
r - Cup Backface "To Clear" Radius	1.30 mm 0.050 in
da - Cone Frontface Backing Diameter	21.10 mm 0.83 in
db - Cone Backface Backing Diameter	22.10 mm 0.87 in
Da - Cup Frontface Backing Diameter	38.61 mm 1.52 in
Ab - Cage-Cone Frontface Clearance	2.3 mm 0.09 in
Aa - Cage-Cone Backface Clearance	0.3 mm 0.01 in
a - Effective Center Location	-1.5 mm -0.06 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	3480 N 782 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	13400 N 3020 lbf
C0 - Static Radial Rating	12300 N 2770 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	3140 N 705 lbf
Factors
K - Factor	1.11
e - ISO Factor	0.53
Y - ISO Factor	1.14
G1 - Heat Generation Factor (Roller-Raceway)	2.9
G2 - Heat Generation Factor (Rib-Roller End)	5.64
Cg - Geometry Factor	0.0404

As TIMKEN bearing distributor, Nodes bearings have TIMKEN A6067-A6157-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.