TIMKEN HH224332-HH224310-B Bearing

TIMKEN HH224332-HH224310-B tapered bearings with Flange

Also known as : HH224332-HH224310-B

• Inside Diameter: 98.425 mm
• Outside Diameter: 212.725 mm
• Width: 23.813 mm
• Basic dynamic load rating: 680 kN
• Basic static load rating: 906 kN

Inquire Now

TIMKEN HH224332-HH224310-B Bearing

Series	HH224300
model	HH224332-HH224310-B
Cone Part Number	HH224332
Cup Part Number	HH224310-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	12.40 Kg 27.40 lb
Dimensions
d - Bore	98.425 mm 3.8750 in
D - Cup Outer Diameter	212.725 mm 8.3750 in
D1 - Flange Outer Diameter	223.733 mm 8.8084 in
B - Cone Width	66.675 mm 2.6250 in
C - Cup Width	53.975 mm 2.1250 in
C1 - Cup Flange Width	11.113 mm 0.4375 in
T - Bearing Width to Flange	23.813 mm 0.9375 in
T1 - Bearing Width	66.675 mm 2.6250 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	3.600 mm 0.14 in
r - Cup Backface "To Clear" Radius	3.30 mm 0.130 in
da - Cone Frontface Backing Diameter	119.10 mm 4.69 in
db - Cone Backface Backing Diameter	122.9 mm 4.84 in
Da - Cup Frontface Backing Diameter	204.47 mm 8.05 in
Ab - Cage-Cone Frontface Clearance	3.8 mm 0.15 in
Aa - Cage-Cone Backface Clearance	4.1 mm 0.16 in
a - Effective Center Location	-18.8 mm -0.74 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	176000 N 39600 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	680000 N 153000 lbf
C0 - Static Radial Rating	906000 N 204000 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	98300 N 22100 lbf
Factors
K - Factor	1.79
e - ISO Factor	0.33
Y - ISO Factor	1.84
G1 - Heat Generation Factor (Roller-Raceway)	367
G2 - Heat Generation Factor (Rib-Roller End)	47.8
Cg - Geometry Factor	0.118

As TIMKEN bearing distributor, Nodes bearings have TIMKEN HH224332-HH224310-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.