TIMKEN HM231132-HM231115-B Bearing

TIMKEN HM231132-HM231115-B tapered bearings with Flange

Also known as : HM231132-HM231115-B

  • Inside Diameter: 139.7 mm
  • Outside Diameter: 241.3 mm
  • Width: 22.225 mm
  • Basic dynamic load rating: 597 kN
  • Basic static load rating: 932 kN

Inquire Now


TIMKEN HM231132-HM231115-B Bearing

TIMKEN HM231132-HM231115-B Bearing details

Series HM231100
model HM231132-HM231115-B
Cone Part Number HM231132
Cup Part Number HM231115-B
Design Units Imperial
Cage Type Stamped Steel
Bearing Weight 10.70 Kg
23.700 lb
Dimensions
d - Bore 139.700 mm
5.5000 in
D - Cup Outer Diameter 241.300 mm
9.5000 in
D1 - Flange Outer Diameter 250.723 mm
9.8710 in
B - Cone Width 56.642 mm
2.2300 in
C - Cup Width 44.450 mm
1.7500 in
C1 - Cup Flange Width 9.525 mm
0.3750 in
T - Bearing Width to Flange 22.225 mm
0.8750 in
T1 - Bearing Width 57.150 mm
2.2500 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius 3.600 mm
0.14 in
r - Cup Backface "To Clear" Radius 3.30 mm
0.130 in
da - Cone Frontface Backing Diameter 156 mm
6.14 in
db - Cone Backface Backing Diameter 160 mm
6.3 in
Da - Cup Frontface Backing Diameter 224.03 mm
8.84 in
Ab - Cage-Cone Frontface Clearance 4.8 mm
0.19 in
Aa - Cage-Cone Backface Clearance 3.6 mm
0.14 in
a - Effective Center Location -11.4 mm
-0.45 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions) 155000 N
34800 lbf
C1 - Dynamic Radial Rating (1 million revolutions) 597000 N
134000 lbf
C0 - Static Radial Rating 932000 N
210000 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions) 84500 N
19000 lbf
Factors
K - Factor 1.83
e - ISO Factor 0.32
Y - ISO Factor 1.88
G1 - Heat Generation Factor (Roller-Raceway) 533
G2 - Heat Generation Factor (Rib-Roller End) 85.9
Cg - Geometry Factor 0.133

As TIMKEN bearing distributor, Nodes bearings have TIMKEN HM231132-HM231115-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.