TIMKEN HM237542-HM237510-B Bearing

TIMKEN HM237542-HM237510-B tapered bearings with Flange

Also known as : HM237542-HM237510-B

• Inside Diameter: 174.625 mm
• Outside Diameter: 288.925 mm
• Width: 26.988 mm
• Basic dynamic load rating: 976 kN
• Basic static load rating: 1240 kN

Inquire Now

TIMKEN HM237542-HM237510-B Bearing

Series	HM237500
model	HM237542-HM237510-B
Cone Part Number	HM237542
Cup Part Number	HM237510-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	16.10 Kg 35.40 lb
Dimensions
d - Bore	174.625 mm 6.8750 in
D - Cup Outer Diameter	288.925 mm 11.3750 in
D1 - Flange Outer Diameter	299.933 mm 11.8084 in
B - Cone Width	63.5 mm 2.5 in
C - Cup Width	47.625 mm 1.8750 in
C1 - Cup Flange Width	11.113 mm 0.4375 in
T - Bearing Width to Flange	26.988 mm 1.0625 in
T1 - Bearing Width	63.500 mm 2.5000 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	7.100 mm 0.280 in
r - Cup Backface "To Clear" Radius	3.30 mm 0.130 in
da - Cone Frontface Backing Diameter	191 mm 7.52 in
db - Cone Backface Backing Diameter	201.9 mm 7.95 in
Da - Cup Frontface Backing Diameter	279.90 mm 11.02 in
Ab - Cage-Cone Frontface Clearance	5.1 mm 0.2 in
Aa - Cage-Cone Backface Clearance	5.1 mm 0.2 in
a - Effective Center Location	-11.7 mm -0.46 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	253000 N 56900 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	976000 N 219000 lbf
C0 - Static Radial Rating	1240000 N 278000 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	138000 N 31100 lbf
Factors
K - Factor	1.83
e - ISO Factor	0.32
Y - ISO Factor	1.88
G1 - Heat Generation Factor (Roller-Raceway)	751
G2 - Heat Generation Factor (Rib-Roller End)	101
Cg - Geometry Factor	0.117

As TIMKEN bearing distributor, Nodes bearings have TIMKEN HM237542-HM237510-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.