TIMKEN HM804846-HM804811-B Bearing

TIMKEN HM804846-HM804811-B tapered bearings with Flange

Also known as : HM804846-HM804811-B

  • Inside Diameter: 47.625 mm
  • Outside Diameter: 95.25 mm
  • Width: 11.14 mm
  • Basic dynamic load rating: 147 kN
  • Basic static load rating: 157 kN

Inquire Now


TIMKEN HM804846-HM804811-B Bearing

TIMKEN HM804846-HM804811-B Bearing details

Series HM804800
model HM804846-HM804811-B
Cone Part Number HM804846
Cup Part Number HM804811-B
Design Units Imperial
Cage Type Stamped Steel
Bearing Weight 1.000 Kg
2.20 lb
Dimensions
d - Bore 47.625 mm
1.8750 in
D - Cup Outer Diameter 95.250 mm
3.7500 in
D1 - Flange Outer Diameter 100.686 mm
3.9640 in
B - Cone Width 29.370 mm
1.1563 in
C - Cup Width 24.021 mm
0.9457 in
C1 - Cup Flange Width 5.001 mm
0.1969 in
T - Bearing Width to Flange 11.140 mm
0.4386 in
T1 - Bearing Width 30.160 mm
1.1874 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius 3.600 mm
0.14 in
r - Cup Backface "To Clear" Radius 3.30 mm
0.130 in
da - Cone Frontface Backing Diameter 57.40 mm
2.26 in
db - Cone Backface Backing Diameter 66 mm
2.6 in
Da - Cup Frontface Backing Diameter 93.47 mm
3.68 in
Ab - Cage-Cone Frontface Clearance 3.6 mm
0.14 in
Aa - Cage-Cone Backface Clearance 0.8 mm
0.03 in
a - Effective Center Location -3.8 mm
-0.15 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions) 38200 N
8590 lbf
C1 - Dynamic Radial Rating (1 million revolutions) 147000 N
33100 lbf
C0 - Static Radial Rating 157000 N
35400 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions) 35700 N
8030 lbf
Factors
K - Factor 1.07
e - ISO Factor 0.55
Y - ISO Factor 1.1
G1 - Heat Generation Factor (Roller-Raceway) 44.8
G2 - Heat Generation Factor (Rib-Roller End) 14.6
Cg - Geometry Factor 0.102

As TIMKEN bearing distributor, Nodes bearings have TIMKEN HM804846-HM804811-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.