TIMKEN L116149-L116110-B Bearing

TIMKEN L116149-L116110-B tapered bearings with Flange

Also known as : L116149-L116110-B

• Inside Diameter: 82.55 mm
• Outside Diameter: 115.888 mm
• Width: 7.938 mm
• Basic dynamic load rating: 90.2 kN
• Basic static load rating: 147 kN

Inquire Now

TIMKEN L116149-L116110-B Bearing

Series	L116100
model	L116149-L116110-B
Cone Part Number	L116149
Cup Part Number	L116110-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	0.700 Kg 1.50 lb
Dimensions
d - Bore	82.550 mm 3.2500 in
D - Cup Outer Diameter	115.888 mm 4.5625 in
D1 - Flange Outer Diameter	119.855 mm 4.7187 in
B - Cone Width	21.433 mm 0.8438 in
C - Cup Width	16.670 mm 0.6563 in
C1 - Cup Flange Width	3.970 mm 0.1563 in
T - Bearing Width to Flange	7.938 mm 0.3125 in
T1 - Bearing Width	20.638 mm 0.8125 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	1.5 mm 0.06 in
r - Cup Backface "To Clear" Radius	1.5 mm 0.06 in
da - Cone Frontface Backing Diameter	87.90 mm 3.46 in
db - Cone Backface Backing Diameter	89.90 mm 3.54 in
Da - Cup Frontface Backing Diameter	113.03 mm 4.49 in
Ab - Cage-Cone Frontface Clearance	1.8 mm 0.07 in
Aa - Cage-Cone Backface Clearance	0.3 mm 0.01 in
a - Effective Center Location	-1.3 mm -0.05 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	23400 N 5260 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	90200 N 20300 lbf
C0 - Static Radial Rating	147000 N 33100 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	12300 N 2770 lbf
Factors
K - Factor	1.9
e - ISO Factor	0.31
Y - ISO Factor	1.95
G1 - Heat Generation Factor (Roller-Raceway)	97.2
G2 - Heat Generation Factor (Rib-Roller End)	64.3
Cg - Geometry Factor	0.108

As TIMKEN bearing distributor, Nodes bearings have TIMKEN L116149-L116110-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.