TIMKEN LM451349-LM451310-B Bearing

TIMKEN LM451349-LM451310-B tapered bearings with Flange

Also known as : LM451349-LM451310-B

• Inside Diameter: 266.7 mm
• Outside Diameter: 355.6 mm
• Width: 22.225 mm
• Basic dynamic load rating: 880000 kN
• Basic static load rating: 1510000 kN

Inquire Now

TIMKEN LM451349-LM451310-B Bearing

Series	LM451300
model	LM451349-LM451310-B
Cone Part Number	LM451349
Cup Part Number	LM451310-B
Design Units	Imperial
Cage Type	Stamped Steel
Bearing Weight	15.70 Kg 34.600 lb
Dimensions
d - Bore	266.7 mm 10.5 in
D - Cup Outer Diameter	355.6 mm 14 in
D1 - Flange Outer Diameter	365.125 mm 14.3750 in
B - Cone Width	57.150 mm 2.2500 in
C - Cup Width	44.450 mm 1.7500 in
C1 - Cup Flange Width	9.525 mm 0.3750 in
T - Bearing Width to Flange	22.225 mm 0.8750 in
T1 - Bearing Width	57.150 mm 2.2500 in
Abutment and Fillet Dimensions
R - Cone Backface "To Clear" Radius	3.600 mm 0.14 in
r - Cup Backface "To Clear" Radius	3.30 mm 0.130 in
da - Cone Frontface Backing Diameter	280.90 mm 11.06 in
db - Cone Backface Backing Diameter	285 mm 11.22 in
Da - Cup Frontface Backing Diameter	343.92 mm 13.58 in
Ab - Cage-Cone Frontface Clearance	4.6 mm 0.18 in
Aa - Cage-Cone Backface Clearance	4.8 mm 0.19 in
a - Effective Center Location	5.1 mm 0.2 in
Basic Load Ratings
C90 - Dynamic Radial Rating (90 million revolutions)	193000 N 43300 lbf
C1 - Dynamic Radial Rating (1 million revolutions)	880000 N 198000 lbf
C0 - Static Radial Rating	1510000 N 339000 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)	141000 N 31600 lbf
Factors
K - Factor	1.62
e - ISO Factor	0.36
Y - ISO Factor	1.67
G1 - Heat Generation Factor (Roller-Raceway)	1550
G2 - Heat Generation Factor (Rib-Roller End)	212
Cg - Geometry Factor	0.154

As TIMKEN bearing distributor, Nodes bearings have TIMKEN LM451349-LM451310-B bearings in stock, TSF (Tapered Single with Flange) Imperial , Tapered roller bearings.

Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.